Ramp slope calculator

Calculate ramp slope, ratio, run, and sloped length.

Enter vertical rise and horizontal run to calculate slope percentage, a 1:X rise-to-run ratio, angle, sloped surface length, and surface area.

← Horizontal ramp run →↕ Vertical riseSloped ramp length
← Horizontal ramp run →↕ Clear ramp widthLevel plan footprint

1 Enter measured geometry

2 Enter project references

Formula and planning method

Ramp slope compares vertical rise with horizontal run.

Slope percent equals rise divided by horizontal run × 100. The 1:X ratio divides horizontal run by rise, and sloped length is the hypotenuse calculated from rise and run. Keep every dimension in compatible units before comparing them.

Measure and check the proposed ramp in three passes

  1. Measure the total vertical change between the level surfaces.
  2. Measure horizontal run in plan view, excluding sloped surface length.
  3. Check landings, cross slope, width, handrails, guards, drainage, and local requirements separately.

For accessible routes covered by the ADA Standards, the U.S. Access Board explains that ramp runs generally may not be steeper than 1:12 and that additional requirements apply. The calculator does not determine whether those standards—or any exception—apply to a project.

Open the verified methodology for formula provenance, assumptions, a worked example, and limitations.